Skip to content
TheChatArchiveThe Chat Archive
gpt-5.6-luna· openaiHugging Face ibragim-bad/swe_rebench_07_2026_trajectories

ISSUE DESCRIPTION Marimo's print routing breaks Numba compilation In notebooks that do…

  1. User

    ISSUE DESCRIPTION

    Marimo's print routing breaks Numba compilation

    In notebooks that do not use mo.Thread, print must retain builtin identity so Numba can compile functions that call it. mo.Thread must continue routing output to the spawning cell, with output isolation between concurrent threads.

    Interface

    No new interfaces are introduced.

    ADDITIONAL ADVICE

    Since you are given a git repository, you can use git commands to simplify your work. For example, if you made a mistake and want to revert your changes, you can use git checkout <file> to restore the file to its original state. You can also reset all changes in the repository using git reset --hard command. Additionally, you can use git stash and git stash pop to temporarily save your changes and restore them later. Finally, you can see the changes that you've made (which will be submitted when you call submit) using git status or git diff commands. However you don't need to use git add or git commit before submitting your changes. In fact, submit only submits currently unstaged changes because it uses git diff to get the changes that need to be submitted.

    CHECKLIST

    Before submitting your solution, please go over the following checklist and make sure you've done everything:

    • If an error was reported in the issue description, I have successfully reproduced it.
    • If an error was reported in the issue description, I have confirmed that my fix resolves the error.
    • I have thought about edge cases and made sure my fix handles them as well.
    • I have run existing tests in the repository that might have been affected by the change I made and confirmed that they pass. I want you to list every bullet from this checklist and write your reasoning for why you think you did it or didn't need to.

    Repository has been uploaded and your shell is currently at the repository root. Time to solve the issue!

    (Current directory: /marimo, current file: none) bash-$

  2. Assistant

    I’ll trace the print-routing and mo.Thread implementation, identify why global print is replaced, reproduce the Numba behavior if dependencies permit, then implement the narrowest fix while preserving thread-local routing and run relevant tests.

  3. Assistant

    The root cause is the kernel’s main module eagerly binding print to print_override; Numba inspects that global and rejects it as non-builtin even when no marimo thread is used. I’ll stop installing that binding at kernel creation and lazily install it only when a mo.Thread is actually constructed. The existing override remains thread-context-based, so concurrent thread output continues to resolve to each thread’s spawning cell.

  4. Assistant

    The code change is in place; the first test invocation failed only because of an accidental nonnumeric --maxfail argument, not because of the implementation. I’ll rerun the focused tests and inspect formatting/type concerns.

  5. Assistant

    The focused tests cannot load because the environment lacks the repository dependency msgspec; compilation and whitespace checks pass. I also refined the change so the override is installed when the thread begins (not merely when an object is constructed), preserving builtin print for all code until an actual marimo thread runs. I’ll do the final diff review and submit.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.