Skip to content
TheChatArchiveThe Chat Archive
DeepSeekdeepseek-v3-0324· DeepSeekHugging Face Arena Expert 5K

in Blackfly S cameras of Teledyne, by default, if I give 12 V on Vaux (Line 3 of the…

  1. User

    in Blackfly S cameras of Teledyne, by default, if I give 12 V on V_aux (Line 3 of the GPIO connector) it gets used to power the camera (instead of taking the power from USB or PoE). Do I have an option to disable this behaviour, and power from USB/PoE even when a voltage is applied to V_aux?

  2. DeepSeek Assistant

    Yes, in Teledyne Blackfly S cameras, the V_aux (Line 3 of the GPIO connector) is designed to provide an alternative power source when connected (typically 12V). By default, if a valid voltage is applied to V_aux, the camera will prioritize it over USB or PoE power.

    Can You Disable This Behavior?

    Unfortunately, there is no direct software or hardware setting to disable the automatic power source selection when V_aux is connected. The camera's power management is hardwired to prioritize V_aux if it detects sufficient voltage.

    Workarounds:

    1. Disconnect V_aux – If you want to use USB or PoE, simply leave V_aux unconnected (or disconnect it).
    2. Use a Switch or Relay – If you need to switch between power sources dynamically, you could use an external switch/relay to enable/disable V_aux as needed.
    3. Check Camera Firmware/Software Settings – While unlikely, some newer firmware versions might allow power source selection via SpinView or the GenICam API (though this is not standard).

    Conclusion:

    If you want to force USB/PoE power, the simplest solution is to not apply voltage to V_aux. If you must keep V_aux connected but prefer USB/PoE, an external switching mechanism may be required.

    Would you like help with GPIO pinout details or alternative power management solutions?

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.