Skip to content
The Chat Archive
command-a-03-2025· Cohere LMArena Human Preference 140K

Hi I have Hikvision DS-9664NI-M8 and i have just unplugged the harddrives out of the…

  1. User

    Hi I have Hikvision DS-9664NI-M8 and i have just unplugged the harddrives out of the system. Now I want to replug them since I want to check back a recording using the device. Given no array functioning is used does it matter if i plug them back to different slots of the machine? Do system can still use any other mechanism to make me inable to do that

  2. Assistant

    The Hikvision DS-9664NI-M8 is a network video recorder (NVR) that typically uses RAID (Redundant Array of Independent Disks) configurations to manage multiple hard drives. However, you mentioned that no array functioning is used, which implies the drives are likely configured in a non-RAID (JBOD or independent) mode.

    Here's how replugging the hard drives into different slots might affect your system:

    1. Non-RAID (JBOD) Configuration:

      • If the drives are in a non-RAID (JBOD) configuration, each drive operates independently, and the NVR treats them as separate storage devices.
      • In this case, you can plug the drives back into different slots without losing data accessibility, as long as the drives themselves are not damaged or corrupted.
      • The NVR should still recognize the drives and allow you to access the recordings stored on them.
    2. No Array Functioning:

      • Since you confirmed no array functioning is used, there’s no dependency on drive order or specific slots for the system to recognize the drives.
      • The NVR will likely detect the drives based on their individual IDs or serial numbers, not their physical positions.
    3. Potential Issues:

      • Drive Damage or Corruption: If a drive was damaged when unplugged or is corrupted, plugging it back in (regardless of the slot) may prevent the system from recognizing it or accessing the data.
      • Firmware or System Settings: If the NVR’s firmware or settings require drives to be in specific slots (which is uncommon for non-RAID setups), you might encounter issues. However, this is unlikely unless explicitly stated in the documentation.

    Steps to Safely Replug the Drives:

    1. Ensure the NVR is powered off before replugging the drives.
    2. Insert the drives into any available slots.
    3. Power on the NVR and check if the system recognizes the drives.
    4. Access the recording interface to verify that the stored recordings are accessible.

    Conclusion: Given that no array functioning is used, you should be able to plug the hard drives back into different slots without issues. The system will likely recognize them and allow you to access the recordings. However, always ensure the drives are in good condition and handle them carefully to avoid physical damage. If you encounter problems, consult the Hikvision documentation or support for further assistance.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.