The FreeCAD has the "Maximum angular deflection" setting affecting how accurately 3d…
- User
The FreeCAD has the "Maximum angular deflection" setting affecting how accurately 3d shapes are shown in UI. With default deflection setting of 28 degrees I observe noticeable roughness in the arched surfaces. What's recommended value for this setting?
Assistant
For smoother curved surfaces in FreeCAD, you'll want to reduce the "Maximum angular deflection" setting significantly from the default 28 degrees. Here are some recommended values:
For general modeling work: 5-10 degrees will provide a good balance between visual quality and performance. This should eliminate most of the visible faceting on curved surfaces while keeping the interface responsive.
For precision work or final visualization: 1-3 degrees will give you very smooth curves, though this will increase computational load and may slow down navigation in complex models.
For basic sketching or simple models: 15-20 degrees might be sufficient if performance is a priority.
The angular deflection controls how much the tessellated mesh can deviate from the actual curved surface. Lower values create more triangular facets to better approximate smooth curves, while higher values use fewer, larger facets that create the visible "roughness" you're seeing.
You can adjust this setting in Edit > Preferences > Display > 3D View. Keep in mind that very low values (under 1 degree) may cause performance issues on complex assemblies, so it's worth experimenting to find the sweet spot for your specific workflow and hardware capabilities.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.