Skip to content
TheChatArchiveThe Chat Archive
gpt-4.1-mini-2025-04-14· OpenAIHugging Face LMArena Human Preference 140K

OK and I have a DSP Readback on the output of a Signal Detection flag block, and the DSP…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-3-7-sonnet-20250219’s answer.
  1. User

    OK and I have a DSP Readback on the output of a Signal Detection flag block, and the DSP Readback is set to 5.19 format. The flag alternates between 1.0 and 0.0 in the Readback. What number format should I say the flag output is in when I edit the wiki? Currently it says:

    Name Format [int/dec] - [control/audio] Function Description

    Pin 0: Trigger any - any Outputs a flag after no signal has been present for a given amount of time

    Context:

    "First-generation SigmaDSP processors, such as ADAU1701, do not read back with 28-bit accuracy. They only support 24-bit data, so small 28.0 format integers will be truncated and display as 0.000000000. To display 28.0 format integers on these DSPs, the value from Readback must be bit shifted, such as multiplying the value by 4 twice (since 16.0 does not exist in 5.23 format) and setting the DSP Readback to 24.0 format."

    "So, in the case of most SigmaDSPs, audio representation is represented with A = 5 and B = 23. In other words, the number format is 5.23. Control signals and index table values generally require integer representation, and are therefore represented with A = 28 and B = 0. In other words, the format is 28.0."

  2. Assistant

    Thanks for the detailed context! Here’s how I would clarify the number format for the Signal Detection flag output in your wiki:


    Recommended Number Format for Signal Detection Flag Output

    Flag output format:
    Since the flag output alternates between 1.0 and 0.0 in the DSP Readback and is essentially a binary control signal (flag), it should be considered an integer control signal rather than an audio signal.

    • Number format: 28.0 (integer)
    • Reason:
      • Control signals like flags are best represented as integers (no fractional bits).
      • The flag values are either 0 or 1, which fits naturally into an integer format.
      • Using 28.0 format ensures the flag is interpreted as a whole number without fractional parts.
      • This matches the convention that control signals and index values use 28.0 format in SigmaDSP processors.

    Additional notes based on your context:

    • The DSP Readback set to 5.19 format is a fixed-point fractional format (5 integer bits, 19 fractional bits), which is more typical for audio signals, not flags.
    • The flag showing 1.0 and 0.0 in 5.19 format is effectively showing integer values in a fractional format, but this is not ideal for documentation or interpretation.
    • For clarity and consistency, document the flag output as 28.0 integer format in the wiki, even if the DSP Readback is currently set to 5.19 for monitoring purposes.

    Example wiki entry snippet:

    Pin 0: Trigger any - any  
    Outputs a flag after no signal has been present for a given amount of time.  
    **Format:** 28.0 (integer control signal)  
    Values: 0 (no flag), 1 (flag active)
    

    If you want, I can help you rewrite the entire section for clarity. Would you like that?

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.