Skip to content
TheChatArchiveThe Chat Archive
Coherecommand-a-03-2025· CohereHugging Face LMArena Human Preference 140K

How to save configuration in ISW-24W-4X CLI?

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-sonnet-4-20250514’s answer.
  1. User

    How to save configuration in ISW-24W-4X CLI?

  2. Cohere Assistant

    To save the configuration on a ISW-24W-4X switch (assuming it's a model from a vendor like TP-Link or similar), you typically use the Command Line Interface (CLI) to ensure that your settings persist across reboots. Below are the general steps to save the configuration. Note that the exact commands might vary slightly depending on the vendor and firmware version.

    Steps to Save Configuration in CLI:

    1. Access the CLI:

      • Connect to the switch via a console cable or SSH/Telnet.
      • Log in with administrative credentials.
    2. Enter Configuration Mode:

      • Type the following command to enter global configuration mode:
        ISW-24W-4X> enable
        ISW-24W-4X# configure terminal
        
    3. Make Your Configuration Changes:

      • Apply the necessary configuration changes (e.g., VLANs, IP addresses, port settings, etc.).
    4. Save the Configuration:

      • After making your changes, save the running configuration to the startup configuration so it persists after a reboot. Use the following command:
        ISW-24W-4X(config)# write memory
        
      • Alternatively, you might see a command like:
        ISW-24W-4X(config)# copy running-config startup-config
        
    5. Verify the Save:

      • To ensure the configuration was saved correctly, you can view the startup configuration:
        ISW-24W-4X# show startup-config
        
    6. Exit the CLI:

      • Type exit or logout to exit the CLI session.

    Example Session:

    ISW-24W-4X> enable
    ISW-24W-4X# configure terminal
    ISW-24W-4X(config)# interface gigabitethernet 1/1
    ISW-24W-4X(config-if)# description Connects to Server Room
    ISW-24W-4X(config-if)# exit
    ISW-24W-4X(config)# write memory
    Configuration saved successfully.
    ISW-24W-4X(config)# exit
    ISW-24W-4X# exit
    

    Notes:

    • If the switch is from a specific vendor (e.g., TP-Link, Cisco, etc.), refer to their official documentation for exact commands.
    • Some switches may have a web interface or other methods to save configurations, but the CLI method is universal and reliable.

    If you're unsure about the exact commands, consult the user manual or vendor support for your specific switch model.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.