Skip to content
TheChatArchiveThe Chat Archive
Human-written demonstration (OpenAssistant volunteers)· OpenAssistant (human-written)Hugging Face OpenAssistant Conversations (oasst2)

Write me a script for the Arduino that blinks the led on the board

In OpenAssistant data, “assistant” turns were written by human volunteers as demonstrations. They are not model outputs.
  1. User

    Write me a script for the Arduino that blinks the led on the board

  2. Assistant

    Here's a simple script for the Arduino that blinks the built-in LED on the board:

    // Define the LED pin
    const int LED_PIN = LED_BUILTIN;
    
    // The setup function runs once when the board is powered or reset
    void setup() {
      // Initialize the LED pin as an output
      pinMode(LED_PIN, OUTPUT);
    }
    
    // The loop function runs continuously after the setup function
    void loop() {
      digitalWrite(LED_PIN, HIGH); // Turn the LED on (HIGH is the voltage level)
      delay(1000);                 // Wait for a second
      digitalWrite(LED_PIN, LOW);  // Turn the LED off by making the voltage LOW
      delay(1000);                 // Wait for a second
    }
    

    This script defines the built-in LED pin (usually pin 13) and sets it as an output. In the loop function, it turns the LED on and off with a delay of 1000 milliseconds (1 second) between each state. The LED will blink continuously with a 1-second interval between on and off states.

  3. User

    nice

  4. Assistant

    Thank you!

    If you have any questions, I'm glad to assist you there.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.