Skip to content
TheChatArchiveThe Chat Archive
Metallama-2-70b-chat· MetaHugging Face Arena Human Preference 55K

Build a bash script that I can run from my lte router running openwrt that will read…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Mistralmixtral-8x7b-instruct-v0.1’s answer.
  1. User

    Build a bash script that I can run from my lte router running openwrt that will read incoming sms and when they contain !status it replies by sms with the lte connection status

  2. Meta Assistant

    Sure, here's a simple bash script that should do what you're asking for:

    #!/bin/bash
    
    # Set the device name and APN for the LTE connection
    DEVICE="qmi-wwan"
    APN="my-apn"
    
    # Read incoming SMS messages
    while true; do
      sms=$(cat /dev/ttyUSB0)
      if [[ $sms =~ "!status" ]]; then
        # Get the LTE connection status
        status=$(sudo /usr/sbin/qmi-client -d $DEVICE -a $APN status)
        reply=$(echo "$status" | awk '{print $3}')
        # Send a reply SMS with the connection status
        sudo /usr/sbin/sms -d $DEVICE -n $reply
      fi
    done
    

    Here's how the script works:

    1. It sets the device name and APN for the LTE connection. You'll need to replace these with the appropriate values for your router and LTE provider.
    2. It enters an infinite loop that reads incoming SMS messages from the serial device /dev/ttyUSB0.
    3. For each incoming SMS message, it checks if the message contains the keyword "!status". If it does, the script proceeds to the next step.
    4. It uses the qmi-client command to get the LTE connection status. The -d option specifies the device name, and the -a option specifies the APN. The status command is used to retrieve the connection status.
    5. It extracts the third field from the output of the qmi-client command using awk. This field should contain the current connection status.
    6. It sends a reply SMS with the connection status using the sms command. The -d option specifies the device name, and the -n option specifies the message to send.

    To use this script, save it to a file (e.g., sms-status.sh), make the file executable with chmod +x sms-status.sh, and then run it with ./sms-status.sh. You can also set up a system service to run the script automatically whenever the router

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.