Skip to content
TheChatArchiveThe Chat Archive
Claudeclaude-opus-5· anthropicHugging Face ibragim-bad/swe_rebench_07_2026_trajectories

ISSUE DESCRIPTION WebServer Idle timeout task lifecycle Part of #11854. Scope Idle…

  1. User

    ISSUE DESCRIPTION

    WebServer Idle timeout task lifecycle Part of #11854.

    Scope

    Idle timeout tasks should be tied to listener lifecycle and cancelled when the listener stops or suspends.

    Current behavior:

    • webserver/webserver/src/main/java/io/helidon/webserver/ServerListener.java creates an IdleTimeoutHandler as a local value and starts it.
    • The listener does not retain the timeout task.
    • Stop and suspend cleanup cannot cancel the idle timeout task explicitly.

    Expected behavior

    • Retain the idle timeout handler or task as listener state.
    • Start the task with listener startup.
    • Cancel the task during listener stop and suspend cleanup.
    • Make cleanup idempotent so repeated stop paths do not fail because the task was already cancelled.

    Implementation notes

    • Keep the change limited to idle timeout lifecycle management.
    • Avoid broader timer or transport refactoring unless it is required for a focused test seam.

    Tests

    Add focused coverage proving:

    • Listener stop cancels the idle timeout task.
    • Listener suspend cancels the idle timeout task.
    • Repeated stop or cleanup paths remain safe.
    • The test should use a small explicit hook or test timer rather than relying on long real-time waits.

    Interface

    No new interfaces are introduced.

    ADDITIONAL ADVICE

    Since you are given a git repository, you can use git commands to simplify your work. For example, if you made a mistake and want to revert your changes, you can use git checkout <file> to restore the file to its original state. You can also reset all changes in the repository using git reset --hard command. Additionally, you can use git stash and git stash pop to temporarily save your changes and restore them later. Finally, you can see the changes that you've made (which will be submitted when you call submit) using git status or git diff commands. However you don't need to use git add or git commit before submitting your changes. In fact, submit only submits currently unstaged changes because it uses git diff to get the changes that need to be submitted.

    CHECKLIST

    Before submitting your solution, please go over the following checklist and make sure you've done everything:

    • If an error was reported in the issue description, I have successfully reproduced it.
    • If an error was reported in the issue description, I have confirmed that my fix resolves the error.
    • I have thought about edge cases and made sure my fix handles them as well.
    • I have run existing tests in the repository that might have been affected by the change I made and confirmed that they pass. I want you to list every bullet from this checklist and write your reasoning for why you think you did it or didn't need to.

    Repository has been uploaded and your shell is currently at the repository root. Time to solve the issue!

    (Current directory: /helidon, current file: none) bash-$

  2. Claude Assistant

    I'll use the edit tools instead.

  3. Claude Assistant

    Now update ServerListener.

  4. Claude Assistant

    Now let me write the test.

  5. Claude Assistant

    All changes are complete and verified. Let me do a final verification run before submitting.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.