Skip to content
TheChatArchiveThe Chat Archive
gpt-4-0125-preview· openaiHugging Face Suzhen/CodeChat

make a linux ffmpeg6.0 arg using pcms16le, 48000 Hz, stero, s16, bitrate 320 kb/s -ac 2…

  1. User

    make a linux ffmpeg6.0 arg using pcm_s16le, 48000 Hz, stero, s16, bitrate 320 kb/s -ac 2 making this arg: ffmpeg -f lavfi -i flite=text='New':voice=awb -o ffm_flt_out.wav ffplay ffm_flt_out.wav better

  2. Assistant

    To create an FFmpeg command that encodes audio with specific parameters such as codec pcm_s16le, sample rate 48000 Hz, stereo, s16 format, and bitrate 320 kb/s, and also uses two audio channels (stereo), you can modify the original command you provided. However, it's important to note a couple of points:

    1. The pcm_s16le format (PCM signed 16-bit little-endian) does not use a bitrate setting in the traditional sense that compressed formats like MP3 or AAC do, since it's a raw audio format. The bitrate for pcm_s16le is determined by the sample rate, bit depth, and number of channels.

    2. The -ac 2 option ensures that the output is stereo, matching your requirements.

    Here's how you can adjust the command:

    ffmpeg -f lavfi -i flite=text='Hello there':voice=awb -acodec pcm_s16le -ar 48000 -ac 2 output.wav
    

    Explanation of the options:

    • -f lavfi tells FFmpeg to use the Libavfilter input virtual device.
    • -i flite=text='Hello there':voice=awb specifies the input. This uses the flite text-to-speech filter with your given text and voice settings.
    • -acodec pcm_s16le sets the audio codec to PCM signed 16-bit little-endian.
    • -ar 48000 sets the audio sample rate to 48000 Hz.
    • -ac 2 ensures the output will be stereo (2 channels).

    However, regarding bit rate, when you're dealing with uncompressed formats like pcm_s16le, instead of specifying a bit rate, you define the quality through sample rate, bit depth, and channels, which implicitly sets the bitrate. For pcm_s16le at 48000 Hz in stereo, each sample is 16 bits, meaning the bitrate calculates as follows:

    Sample Rate x Bit Depth x Channels = Bitrate
    48000 samples/second * 16 bits/sample * 2 channels = 1,536,000 bits/second (or approximately 1.5 Mb/s)
    

    Finally, to then play the output file with ffplay, use:

    ffplay output.wav
    

    Note that your specific requirement for a 320 kb/s bitrate would typically apply to compressed formats. With pcm_s16le, the quality and "bitrate" is inherently set by the sample rate, bit depth, and number of channels as shown above.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.