Skip to content
TheChatArchiveThe Chat Archive
gpt-3.5-turbo-0613· openaiHugging Face Suzhen/CodeChat

I need a pause code for a octoprint controlled ender 3 printer that when I pause the…

  1. User

    I need a pause code for a octoprint controlled ender 3 printer that when I pause the print head moves out of the way for a filament change then when I resume print picks up where I left off.

  2. Assistant

    To create a custom pause code for your OctoPrint-controlled Ender 3 printer that moves the print head out of the way for a filament change and then resumes from the same point when you resume the print, you can use the following G-code commands:

    Pause code:

    G91 ; Set to relative positioning mode
    G1 Z5 F300 ; Lift the print head 5mm to clear the print
    G90 ; Set back to absolute positioning mode
    M0 ; Pause the print and wait for user input
    

    Resume code:

    G92 E0 ; Zero the extruder position
    G1 E5 F100 ; Prime the extruder by moving 5mm
    G92 E0 ; Zero the extruder position again
    G92 E[previous E value] ; Restore the previous E value
    G1 F200 ; Set the feedrate to a reasonable value (adjust if needed)
    

    Please note that it's important to use these codes as guidelines and adapt them to your specific setup and preferences. Test the pause and resume codes carefully to ensure they work as intended on your printer.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.