Skip to content
TheChatArchiveThe Chat Archive
gpt-3.5-turbo-0301· openaiHugging Face Suzhen/CodeChat

how to reset mips cpu by assembly instructions?

  1. User

    how to reset mips cpu by assembly instructions?

  2. Assistant

    To reset the MIPS CPU using assembly instructions, you need to jump to the reset vector address, which is located at the beginning of the interrupt vector table in memory. Here is an example code snippet to achieve this:

    li $sp, 0x7fffeffc   # Set the stack pointer to the top of the memory
    li $t0, 0xbfc00000   # Load the reset vector address
    jr $t0              # Jump to the reset vector
    

    The first instruction sets the stack pointer to the top of the memory, which is the highest address in the memory. The second instruction loads the reset vector address to the temporary register t0.Finally,thelastinstructionjumpstotheresetvectoraddressspecifiedint0. Finally, the last instruction jumps to the reset vector address specified in t0.

    Note that the reset vector address may vary depending on the system design. Check the system manual or data sheet to obtain the correct address value.