Skip to content
TheChatArchiveThe Chat Archive
gpt-3.5-turbo-0613· openaiHugging Face Suzhen/CodeChat

I have the paths /hdd2/data and /home/x/data merged into /home/x/realdata using…

  1. User

    I have the paths /hdd2/data and /home/x/data merged into /home/x/realdata using mergerfs. When I create a file in /home/x/realdata, it is only created to /hdd2/data. Will the path /home/x/data start filling up when /hdd2/data runs out of space?

  2. Assistant

    No, the path /home/x/data will not start filling up when /hdd2/data runs out of space.

    Mergerfs is a union filesystem that combines multiple directories into a single directory, but it does not have any built-in mechanisms to handle disk space allocation or redistribution. When you create a file in /home/x/realdata, it will be created in the underlying directory that has the most available space, which in your case is /hdd2/data.

    If /hdd2/data runs out of space, any subsequent file creations will fail until space is made available within that directory. The /home/x/data directory will not automatically start filling up with data. You would need to manually move or free up space within /hdd2/data for any further files to be created in /home/x/realdata.

  3. User

    What is the easiest way then to handle the following scenario: I have two disks A and B. I want to have a folder on disk A (/home/x/data) where I can download files and it will automatically fill both disk A and B.

  4. Assistant

    To automatically fill both disk A and B when downloading files to a folder on disk A (/home/x/data), you can use a disk spanning or disk striping technique called RAID (Redundant Array of Independent Disks).

    There are different RAID levels that offer various features and performance characteristics. In your case, you might want to consider RAID 0 or JBOD (Just a Bunch Of Disks) configuration, as they combine multiple disks to appear as a single volume but don't offer any redundancy.

    Here's a general overview of how to set up such a configuration:

    1. Ensure that both disks A and B are formatted and mounted properly on your system.

    2. Install and configure software RAID tools if they are not already installed. On most Linux distributions, you can use mdadm for software RAID management.

    3. Create a RAID 0 (striped) or JBOD array with both disks A and B. For example, using mdadm:

    sudo mdadm --create /dev/md0 --level=stripe --raid-devices=2 /dev/sda1 /dev/sdb1
    

    Make sure to replace /dev/sda1 and /dev/sdb1 with the appropriate device paths for disks A and B.

    1. Format the RAID array with the desired filesystem. For example, to use ext4:
    sudo mkfs.ext4 /dev/md0
    
    1. Create a mount point for the RAID array:
    sudo mkdir /mnt/raid
    
    1. Edit the /etc/fstab file to add an entry for the RAID array, so it can be automatically mounted on boot. Add a line like this:
    /dev/md0       /mnt/raid       ext4    defaults        0       0
    
    1. Mount the RAID array:
    sudo mount -a
    
    1. Verify that the RAID array is working correctly and can be accessed from /mnt/raid.

    Now, when you download files to the folder /mnt/raid (you can change this path according to your preference), they will automatically be written to both disk A and B, effectively expanding the available storage capacity.

    Keep in mind that RAID 0 and JBOD do not provide any data redundancy. If one disk fails, you may lose all data. It is essential to have proper backup mechanisms in place to ensure data safety.