How to turn "Tunnel All" option on in cisco vpn
- User
How to turn "Tunnel All" option on in cisco vpn
- Assistant
Got it — you’re asking about enabling the “Tunnel All” option (also called “Tunnel All Traffic” or Full-Tunnel Mode) in Cisco VPN. This setting ensures that all your client traffic (including Internet traffic) is routed through the VPN tunnel, instead of just the corporate subnets. Here’s how to do it depending on your setup:
🔹 If You’re an End User Using Cisco AnyConnect Cisco AnyConnect client doesn’t let the user manually force “Tunnel All” — it’s controlled by the VPN administrator on the ASA/Firepower appliance you’re connecting to.
When you connect, the profile pushed by the VPN gateway determines split tunneling or full tunneling.
You cannot override it locally from the client GUI.
So if you’re just using AnyConnect, you’ll need to ask your VPN admin to enable it server-side.
🔹 If You’re the VPN Administrator (ASA / Firepower) You control “Tunnel All” on the VPN headend (ASA/FTD). Steps:
Open ASDM or CLI on the ASA.
Navigate to: Configuration → Remote Access VPN → Network (Client) Access → Group Policies.
Select the Group Policy your VPN users are using.
Click Edit.
Go to the Advanced tab → Split Tunneling.
In the Policy dropdown, choose “Tunnel All Traffic” instead of “Tunnel Network List Below”.
Apply and save your changes.
CLI equivalent: bashCopiar códigogroup-policy <GROUP_POLICY_NAME> attributes split-tunnel-policy tunnelall
Disconnect and reconnect the client — now all traffic will be tunneled through the VPN.
🔹 If You’re Using Cisco VPN Client (Legacy IPSec) Older Cisco VPN Client (pre-AnyConnect):
Go to Connection Entry > Modify > Transport tab.
The “Allow Local LAN Access” box is for split-tunneling.
To tunnel all, make sure “Allow Local LAN Access” is unchecked.
Ultimately, though, full tunnel is still controlled by the .PCF or ASA configuration.
✅ Summary
End user: Can’t enable it locally in AnyConnect; it’s set by the VPN admin.
Admin: Set split-tunnel-policy tunnelall in the group policy or use ASDM GUI.
Legacy client: Uncheck “Allow Local LAN Access” but still depends on profile.
Would you like me to give step-by-step screenshots (ASDM GUI) for this, or just CLI commands?