If I do a J perm, then a Y perm (no rotations), what PLL do I get?
- User
If I do a J perm, then a Y perm (no rotations), what PLL do I get?
- Assistant
If you perform a J perm followed immediately by a Y perm on a solved 3x3 Rubik’s Cube (with no cube rotations in between), the resulting PLL case is a Z perm.
Explanation
- J Perm: Swaps two adjacent corners and two adjacent edges. There are two J perms (Ja and Jb), but both have the same effect in this context: they disrupt the solved state by cycling two corners and two edges.
- Y Perm: Swaps two diagonally opposite corners and three edges in a specific cycle.
When you apply a J perm and then a Y perm (with no rotations), the combined effect is that all four edges on the last layer are cycled diagonally, while all corners return to their original positions. This is the defining characteristic of the Z perm: all corners are solved, and the four edges are swapped in two diagonal pairs[5][6].
Summary Table
Step Resulting PLL State Solved Cube Solved + J Perm J Perm state + Y Perm Z Perm state (edges only) Recognition
- Z Perm: All four last-layer edges are swapped diagonally; all corners are solved[5][6].
Additional Note
This result is independent of whether you use Ja or Jb, as both, when followed by a Y perm (with no rotations), will produce a Z perm. The key is that the combination cycles all four edges without disturbing the corners, which is unique to the Z perm among PLLs[5][6].
In summary:
If you do a J perm, then a Y perm (no rotations), you get a Z perm.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.