Skip to content
TheChatArchiveThe Chat Archive
Geminigemini-2.0-flash-grounding· GoogleHugging Face LMArena Search Arena 24K

can you find the gcode to calibrate the bambu nozzle gap, to fix the nozzle covered…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Geminigemini-2.5-pro-exp-03-25-grounding’s answer.
  1. User

    can you find the gcode to calibrate the bambu nozzle gap, to fix the nozzle covered filament error

  2. Gemini Assistant

    Unfortunately, I haven't found a direct G-code to calibrate the nozzle gap for Bambu printers to specifically address the "nozzle covered in filament" error. However, I can offer some helpful information and steps to troubleshoot and potentially resolve the issue:

    Understanding the Problem

    The "nozzle covered in filament" error (HMS_0300-1A00-0002-0001) on Bambu Lab printers, particularly the A1 series, indicates that the printer detects an obstruction or excessive force on the nozzle. This can happen if:

    • Filament is sticking to the nozzle.[[1]]
    • The build plate is not placed correctly.[[2]][[3]]
    • There are foreign objects around the heat bed.[[2]]

    The printer uses an extrusion force sensor to detect these issues.[[2]]

    Troubleshooting Steps

    1. Clean the Nozzle: This is the most basic and often the most effective solution. Remove any filament buildup on the nozzle.

    2. Check Build Plate Placement: Ensure the build plate is correctly installed and not skewed. If a skewed plate doesn't affect the current print, you can temporarily disable the detection, but re-enable it before the next print.

    3. Clear Foreign Objects: Make sure there are no obstructions around the print bed that could interfere with the nozzle's movement.

    4. Disable Detection (Temporary): In the printer settings, you can temporarily turn off "filament tangle detection," "nozzle clumping," and "build plate detection" to see if the error persists. However, this is not a permanent solution.

    5. Inspect and Clean the Alignment Guide: If you're using a plate alignment guide, check if filament has accumulated on it, preventing the nozzle from touching the bed properly. Consider removing or modifying the guide.[[1]]

    6. First Layer Calibration:

      • The "stress-free First Layer calibration" helps you adjust the Z level.[[4]]
      • During printing, you can adjust the Z offset to raise or lower the nozzle.
    7. Filament and Slicer Settings:

      • Try different infill patterns.
      • If you're printing multiple parts, try changing the print sequence to "by object".[[5]]

    Manual Bed Leveling/Tramming (If Applicable)

    1. G-code for Manual Tramming:
      • Load the G-code file into the printer.[[6]] The printer will home and then move to the front left corner.[[6]]
      • Adjust the bed leveling knob until the nozzle barely touches the printing surface (no gap, but not pushing hard).[[6]]
      • Repeat for the back and front right bed leveling knobs.
      • The process repeats two more times with shorter pauses for fine-tuning.[[6]]

    Important Considerations

    • Firmware/Slicer Version: Some users have reported that downgrading to an older version of the slicer or firmware can resolve false error messages.
    • Contact Support: If none of these steps work, consider submitting a technical ticket to Bambu Lab support, including pictures or videos of the problem.

    While a specific G-code for nozzle gap calibration isn't readily available, these troubleshooting steps should help you address the "nozzle covered in filament" error on your Bambu Lab printer.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.