in riscv hypervisor extension spec, there is a sentence "When an MRET instruction is…
- User
in riscv hypervisor extension spec, there is a sentence "When an MRET instruction is executed, the virtualization mode V is set to MPV, unless MPP=3, in which case V remains 0." However, I only know there is misa register with a V bit. This V bit refers to vector extension; not virtualization. Please help identify where does the "virtualization mode V" exist? In a register???
- Assistant
In the RISC-V hypervisor extension, the "virtualization mode V" is a bit in the mstatus register, not the misa register.
Specifically:
- mstatus.V (bit 63 in RV64, bit 31 in RV32) indicates the current virtualization mode
- When V=1, the hart is executing in VS-mode (Virtual Supervisor) or VU-mode (Virtual User)
- When V=0, the hart is executing in a non-virtualized mode (M, HS, or U)
You're right that misa.V refers to the vector extension - these are completely different V bits serving different purposes.
The sentence you quoted is explaining that during MRET:
- Normally, mstatus.V gets set to mstatus.MPV (which stores the previous virtualization state)
- However, if MPP=3 (returning to M-mode), then V must stay 0 because M-mode cannot be virtualized
The hypervisor extension also adds the MPV bit to mstatus, which stores the previous virtualization mode, similar to how MPP stores the previous privilege mode.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.