Skip to content
TheChatArchiveThe Chat Archive
Mistralmistral-medium-2505· Mistral AIHugging Face LMArena Human Preference 140K

Dealer Factory Reset IQ Panel 4.

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-sonnet-4-20250514-thinking-32k’s answer.
  1. User

    Dealer Factory Reset IQ Panel 4.

  2. Mistral Assistant

    To perform a Dealer Factory Reset on the Qolsys IQ Panel 4, follow these steps. This type of reset is typically used by alarm dealers or installers to fully restore the panel to its original state, including removing all user data, configurations, and dealer settings.


    Steps for Dealer Factory Reset (IQ Panel 4):

    1. Access the Installer Menu:

      • Swipe down from the top of the home screen to open the Admin Menu.
      • Enter the Installer Code (default is 1111 if not changed).
    2. Navigate to Advanced Settings:

      • Go to Settings (gear icon).
      • Select Advanced Settings.
      • Enter the Installer Code again if prompted.
    3. Perform the Dealer Reset:

      • Scroll down and select Reset Panel.
      • Choose Dealer Reset (this is different from a standard factory reset).
      • Confirm the reset by selecting Yes.
    4. Wait for the Reset to Complete:

      • The panel will reboot and restore to dealer default settings.
      • This may take a few minutes.
    5. Reconfigure the Panel:

      • After the reset, you’ll need to:
        • Set up Wi-Fi.
        • Re-enter the Installer Code (default: 1111).
        • Reprogram sensors, users, and dealer-specific settings.

    Alternative Method (Hard Reset - If Panel is Unresponsive):

    If the panel is frozen or unresponsive, you can perform a hard reset:

    1. Remove the panel from its mount (if possible).
    2. Locate the reset button (small pinhole on the side or back).
    3. Press and hold the reset button for 10-15 seconds until the screen turns off.
    4. Release the button and let the panel reboot.

    Important Notes:

    • A Dealer Reset will erase all user data, configurations, and dealer settings, returning the panel to its original state.
    • You may need to reconnect to your alarm monitoring service after the reset.
    • If you’re unsure, contact Qolsys support or your alarm dealer for assistance.

    Would you like help with any specific part of the setup after the reset?

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.