Skip to content
TheChatArchiveThe Chat Archive
Geminigemini-2.5-flash-preview-04-17· GoogleHugging Face LMArena Human Preference 140K

My shower door is 60 cm, the whole width is contained between two walls with a length of…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with o4-mini-2025-04-16’s answer.
  1. User

    My shower door is 60 cm, the whole width is contained between two walls with a length of 1.6m in total. i plan a shower glass 2m high. a sketch is: Wall| <-glass 50cm->|<-Door 60cm->|<-glass 50cm->|Wall. Walls are concrete, ceiling is plasterboard. How many clamps and hinges do I have to order to fix the shower glass. 10mm shower glass

  2. Gemini Assistant

    Okay, let's break down the hardware needed for your shower enclosure based on your sketch:

    Wall | (50cm Glass) | (60cm Door) | (50cm Glass) | Wall

    You have two fixed glass panels (50cm wide x 2m high) and one shower door (60cm wide x 2m high), all 10mm thick.

    Here's the required hardware:

    1. Hinges for the Door: The shower door needs to pivot. It will hinge off one of the fixed glass panels (let's assume it swings outwards).

      • For a 2m high, 10mm thick glass door of this width, 3 hinges are strongly recommended for stability and weight distribution. These will be glass-to-glass hinges.
    2. Clamps for the Fixed Panels: The two fixed glass panels need to be secured to the concrete walls.

      • Each fixed panel (50cm wide x 2m high) needs to be secured along its 2m edge to the wall.
      • For a 2m height, standard practice is to use 3 clamps per panel, spaced evenly (top, middle, bottom).
      • You have two fixed panels, so you need 3 clamps for the left panel on the left wall and 3 clamps for the right panel on the right wall.
      • Total clamps needed: 3 + 3 = 6 clamps. These will be glass-to-wall clamps.

    Summary:

    • You will need 3 x Glass-to-Glass Hinges for the shower door.
    • You will need 6 x Glass-to-Wall Clamps for the two fixed panels.

    Important Considerations:

    • Hardware Quality: Ensure the hardware (hinges and clamps) is specifically designed for 10mm thick shower glass and is made from suitable materials (like solid brass or stainless steel) for a wet environment.
    • Installation: Concrete walls are good for fixing, but proper drilling and suitable fixings (screws and anchors) are crucial. Plasterboard ceilings are not typically load-bearing for shower glass in this configuration.
    • Seals: While not clamps or hinges, you will also need seals (like clear silicone or plastic strips) for the gaps between the glass panels and the door for waterproofing.
    • Bottom Support: The bottom edge of the glass panels and door may sit on a minimal channel or sill for stability and sealing, though the primary structural support comes from the wall clamps and hinges.
    • Manufacturer Recommendations: Always double-check the specific hardware manufacturer's recommendations for the number of hinges/clamps required for the size and weight of your glass panels. My recommendation of 3 hinges and 3 clamps per fixed panel is standard practice for 10mm glass at this height.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.