Skip to content
TheChatArchiveThe Chat Archive
o3-2025-04-16· OpenAIHugging Face LMArena Human Preference 140K

What is an error in kawasaki robot: "program have been cancelled because of unexpected…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Googlegemma-3-27b-it’s answer.
  1. User

    What is an error in kawasaki robot: "program have been cancelled because of unexpected termination. Select a program, reset the error, and make coincidence."?

  2. Assistant

    Kawasaki controllers throw that (slightly “Jap-English”) message when the robot was in the middle of executing a program and the execution flow was broken in a way the controller did not expect.
    In Kawasaki terminology the task is therefore cancelled and the controller does not know which program / which step it is supposed to continue from, so it asks you to:

    1. “Select a program” → tell me which program you want to run next.
    2. “Reset the error” → clear the fault record so the servos can be re-enabled.
    3. “Make coincidence” → make sure the program pointer (and sometimes the robot’s physical position) coincides with the start point you are about to run from.

    Why did it happen?

    Typical causes are:

    • Emergency-stop, power-off, or Deadman released while the robot was in the middle of a motion.
    • The program was edited, deleted or renamed while it was being executed.
    • A CANCEL instruction was executed from another task / signal.
    • A serious run-time error (e.g. illegal JMP/LABEL, index overflow, etc.) that forced an abort.
    • Loss of external start signal or field-bus “RUN” bit during execution (seen in some PLC-controlled cells).

    What you have to do

    1. Switch the teach pendant to TEACH mode (safe position).
    2. AUX → Program → Select → choose the program you intend to run (often your main program).
    3. Hold SHIFT + RESET (or press the “Reset” soft-key) until the red error banner disappears.
    4. Press the “COINC” or “MAKE COINC” soft-key.
      • This aligns the program pointer to the first executable line.
      • If you are using absolute encoders / JT-COORD, the controller may also check that the recorded start position and the actual joint positions coincide.
    5. Turn the mode selector back to AUTO, enable the servos (dead-man/ MOTOR ON), and start the cycle again (EXTERNAL START or PLAY + FWD).

    If “MAKE COINCIDENCE” fails

    1. The robot is physically not at (or near) the recorded start point.
      → Jog the robot to the start pose indicated in the program comment or teaching sheet, then press MAKE COINC again.
    2. You lost absolute encoder data (battery change, encoder error).
      → Perform “ABS DATA SET” or full re-homing procedure, then reboot, select program and MAKE COINC.
    3. Program pointer confusion (multiple tasks).
      → Make sure all tasks are stopped (AUX 0105 TASK MONITOR → STOP ALL), then repeat the steps above.

    How to prevent it

    • Do not power-off or hit E-STOP while motion is in progress.
    • Avoid editing or deleting programs that are currently being executed.
    • Add proper error trapping (TWAIT, SIGNAL monitoring) if you are using external CANCEL signals.
    • Make sure the PLC keeps the RUN request ON as long as the robot is in cycle.

    In short, the message is not signaling damage; it is telling you “I lost track of where I was, please realign me with a program and clear the fault.” Follow the three steps—Select Program → Reset → Make Coincidence—and you should be ready to run again.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.