Skip to content
TheChatArchiveThe Chat Archive
Metallama-3.3-70b-instruct· MetaHugging Face LMArena Human Preference 140K

So when designing a mixer that has a "line" input that feeds an ADC, at "nominal" gain…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-3-7-sonnet-20250219’s answer.
  1. User

    So when designing a mixer that has a "line" input that feeds an ADC, at "nominal" gain (around the middle of the knob I guess), +4 dBu should map to maybe -18 dBFS, so that the peaks can reach 0 dBFS? and then there should be more gain available above that, for weaker signals like -10 dBV signal sources which can also be expected to have 18 dB crest factor? what other signal levels should a line input be able to handle? are there standards or best practice guidelines for this? I need to figure out how much gain I need.

  2. Meta Assistant

    When designing a mixer with a "line" input that feeds an ADC, it's common to aim for a nominal gain setting that maps +4 dBu to around -18 dBFS to -20 dBFS. This allows for sufficient headroom to accommodate peaks without clipping, as you mentioned.

    To accommodate weaker signal sources, such as -10 dBV, you'll want to provide additional gain above the nominal setting. A good rule of thumb is to provide enough gain to bring the weakest expected signal up to the nominal level (-18 dBFS to -20 dBFS).

    For professional audio equipment, the AES (Audio Engineering Society) and SMPTE (Society of Motion Picture and Television Engineers) provide guidelines for signal levels. Here are some common signal levels you might encounter:

    • +4 dBu (1.228 Vrms): Professional line level, nominal
    • -2 dBV (0.613 Vrms): Semi-professional line level
    • -10 dBV (0.316 Vrms): Consumer line level
    • -20 dBV (0.1 Vrms): Low-level signal sources (e.g., some instrument pickups)

    As for the amount of gain needed, it's common to provide a range of around 20-40 dB of gain on a line input. This allows for:

    • Bringing weak signals up to the nominal level
    • Accommodating a range of signal sources with different levels
    • Providing some flexibility for the user to adjust the gain to their needs

    Here's a possible gain structure for a line input:

    • Nominal gain: +4 dBu maps to -18 dBFS (e.g., 20-25 dB of gain)
    • Minimum gain: -20 dBV maps to -18 dBFS (e.g., 40-45 dB of gain)
    • Maximum gain: +20 dBu maps to -18 dBFS (e.g., 0-5 dB of gain)

    Keep in mind that these are general guidelines, and the specific gain requirements will depend on your mixer's intended application, the types of signal sources you expect to encounter, and the desired level of flexibility.

    It's also important to consider the noise floor and distortion characteristics of your ADC and gain stages when designing the gain structure. You may want to consult the datasheets for your ADC and other components to determine the optimal gain settings and noise performance.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.