I have a freezer that I moved from the basement to upstairs. Waited a few hours before…
- User
I have a freezer that I moved from the basement to upstairs. Waited a few hours before connecting again. It started, compressor working fine on Eco mode. I changed to normal -18c mode. Compressor continued working. A few hours later compressor is not working and internal temperature is raising. Unplugging for 10-15 mints and plugging again does not work. Neither does changing the mode to eco or superfreeze from normal. Any tips? Get a new one?
- Assistant
Before you write it off, let’s do a quick diagnostic. The symptoms you describe—compressor running initially, then stopping and not restarting—point to a few common issues that might be fixable without replacing the whole unit.
Step-by-step checks:
1. Listen for clicks or hums
- When you plug it back in, do you hear a click from the back (relay/overload) or a brief hum from the compressor that then stops?
- Click but no start = likely start relay or overload protector failure.
- No sound at all = could be thermostat, control board, or compressor itself.
2. Check the compressor
- Feel the compressor (usually at the back bottom). Is it hot to the touch?
- If it’s very hot, it might have overheated and the overload protector has tripped. Let it cool down for 2–4 hours unplugged, then try again.
- If it’s cold, the compressor isn’t even trying to start—could be a control issue.
3. Test the thermostat
- Try turning the thermostat to the coldest setting and listen for any response.
- If nothing happens, the thermostat or control board might not be signaling the compressor to start.
4. Inspect the start relay (if you're comfortable)
- Unplug the freezer.
- Remove the rear panel and locate the small box attached to the side of the compressor.
- Pull off the relay (usually a plastic cube) and shake it gently. If it rattles or smells burnt, it’s likely failed. These are cheap and easy to replace (~$20–40).
5. Check for voltage
- If you have a multimeter and feel safe doing so, check if 120V (or 220V depending on your region) is reaching the compressor when it should be running. If yes, and it’s not starting, the compressor or relay is the issue.
TL;DR:
- Compressor hot + no start = likely start relay or overload issue.
- Compressor cold + no sound = likely thermostat/control board.
- Compressor tries to start but clicks off = relay or compressor failure.
Should you replace it?
If the compressor itself is seized or shorted (rare but possible), then yes—replacement is usually not cost-effective. But if it’s just a relay or thermostat, those are cheap fixes.
Let me know what you hear or feel when you plug it in again, and I can help narrow it down.
- When you plug it back in, do you hear a click from the back (relay/overload) or a brief hum from the compressor that then stops?
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.