Skip to content
TheChatArchiveThe Chat Archive
Claudeclaude-sonnet-4-20250514· AnthropicHugging Face LMArena Human Preference 140K

arduino code. 2 potis to control 2 servos

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-sonnet-4-20250514-thinking-32k’s answer.
  1. User

    arduino code. 2 potis to control 2 servos

  2. Claude Assistant

    Here's Arduino code to control 2 servos with 2 potentiometers:

    #include <Servo.h>
    
    Servo servo1;
    Servo servo2;
    
    int pot1Pin = A0;    // First potentiometer on analog pin A0
    int pot2Pin = A1;    // Second potentiometer on analog pin A1
    int servo1Pin = 9;   // First servo on digital pin 9
    int servo2Pin = 10;  // Second servo on digital pin 10
    
    void setup() {
      servo1.attach(servo1Pin);
      servo2.attach(servo2Pin);
      Serial.begin(9600);  // Optional: for debugging
    }
    
    void loop() {
      // Read potentiometer values (0-1023)
      int pot1Value = analogRead(pot1Pin);
      int pot2Value = analogRead(pot2Pin);
      
      // Map potentiometer values to servo angles (0-180 degrees)
      int servo1Angle = map(pot1Value, 0, 1023, 0, 180);
      int servo2Angle = map(pot2Value, 0, 1023, 0, 180);
      
      // Move servos to calculated positions
      servo1.write(servo1Angle);
      servo2.write(servo2Angle);
      
      // Optional: print values for debugging
      Serial.print("Pot1: ");
      Serial.print(pot1Value);
      Serial.print(" -> Servo1: ");
      Serial.print(servo1Angle);
      Serial.print(" | Pot2: ");
      Serial.print(pot2Value);
      Serial.print(" -> Servo2: ");
      Serial.println(servo2Angle);
      
      delay(15);  // Small delay for smooth servo movement
    }
    

    Wiring:

    • Potentiometer 1: Connect to A0, 5V, and GND
    • Potentiometer 2: Connect to A1, 5V, and GND
    • Servo 1: Signal wire to pin 9, power to 5V, ground to GND
    • Servo 2: Signal wire to pin 10, power to 5V, ground to GND

    The code reads the analog values from both potentiometers, maps them to servo angles (0-180°), and continuously updates the servo positions. The serial output is optional for monitoring the values.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.