Skip to content
TheChatArchiveThe Chat Archive
gpt-4.1-2025-04-14· OpenAIHugging Face LMArena Human Preference 140K

let's say that I wanted to make a hot water heater that uses bitcoin miners as a heating…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Geminigemini-2.5-flash-preview-04-17’s answer.
  1. User

    let's say that I wanted to make a hot water heater that uses bitcoin miners as a heating element, how hot can this thing get without destroying the miners themselves?

  2. Assistant

    Great question! Using Bitcoin miners as a heat source for a hot water heater is a clever way to repurpose the waste heat they generate. However, there are important thermal limits to consider to avoid damaging the miners.

    Key Points:

    1. Typical Operating Temperatures

    • Bitcoin miners (ASICs) are designed to operate safely at ambient air temperatures up to about 35–40°C (95–104°F).
    • The internal chip temperature can be much higher, but the air entering the miner should ideally stay below this range for long-term reliability.

    2. Water as a Cooling Medium

    • If you use water cooling (direct or indirect), you can keep the chips cooler than with air, but the inlet water temperature should still be kept below 50°C (122°F) to avoid overheating the chips and other components (like power supplies, capacitors, etc.).
    • Most electronics are not rated for continuous operation above 60°C (140°F).

    3. Practical Hot Water Heater Temperatures

    • Domestic hot water is typically stored at 50–60°C (122–140°F).
    • If you want to use the miners as a heating element, you should not exceed 50°C (122°F) water temperature at the point where it cools the miners.

    4. Risks of Higher Temperatures

    • Above 60°C (140°F), you risk:
      • Thermal throttling (miners slow down to avoid damage)
      • Component failure (especially capacitors and solder joints)
      • Shortened lifespan of the miners

    5. System Design Tips

    • Use a heat exchanger: Don’t submerge miners directly in water unless you’re using a dielectric coolant (like mineral oil).
    • Monitor chip and water temperatures closely.
    • Set up automatic shutdowns if temperatures exceed safe limits.

    Summary Table

    ComponentMax Safe Temp (°C)Notes
    ASIC Chip (internal)~80–90Short bursts, not sustained
    Inlet Air35–40For air-cooled miners
    Inlet Water40–50For water-cooled setups
    Hot Water Storage50–60Domestic hot water, but risky for miners

    Bottom Line

    Keep the water temperature entering the miners below 50°C (122°F) for safety and longevity. You can store water at higher temperatures, but the water used to cool the miners should be kept at or below this threshold.

    If you want to discuss specific miner models or cooling setups, let me know!

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.