Skip to content
TheChatArchiveThe Chat Archive
o3-2025-04-16· OpenAIHugging Face LMArena Human Preference 140K

2mm mesh back vs 1mm mesh back, which phone case is likely to be more heat dissipating

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Mistralmistral-medium-2505’s answer.
  1. User

    2mm mesh back vs 1mm mesh back, which phone case is likely to be more heat dissipating

  2. Assistant

    Short answer
    Assuming the two cases are made of the same material and use the same perforation pattern, the 1 mm-thick mesh back will usually let a phone run cooler than a 2 mm-thick mesh back.

    Why?
    Heat has to travel through the case material before it can reach the outside air that’s flowing through the holes. That conduction step is governed (simplified) by:

     𝑅_cond = L / (k · A)

     • L = thickness of the material path
     • k = thermal conductivity of the material (same for both if they’re the same plastic)
     • A = cross-sectional contact area with the phone

    If you double the thickness (1 mm → 2 mm) while everything else stays the same, you roughly double the conduction resistance. More resistance = slower heat flow = slightly higher internal phone temperature.

    What about “extra air space”?
    With a mesh case the phone isn’t pressed against a solid wall anyway; air is already circulating through the holes. Adding another 1 mm of plastic does not meaningfully increase effective airflow or create a helpful “chimney.” It mainly adds:

    • More insulating plastic between the phone and the ambient air
    • More thermal mass (it can absorb a little more heat, but only temporarily)

    Edge cases (pun intended 😉)
    There are situations where the thicker mesh could win, but they require other variables to change:

    1. Material change: If the 2 mm case were made of aluminum or graphene-filled polymer (much higher k) and the 1 mm case were ordinary TPU, the thicker one could actually be cooler.
    2. Finned design: If the extra thickness is used to add tall fins that stick out of the back, the surface area exposed to air goes up and convection improves.
    3. Active airflow: With a fan dock or strong external airflow, thickness matters less because convection dominates.

    Rule of thumb
    Same material + same hole pattern → thinner mesh dissipates better.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.