D=0;ST=12;%日期、当地时间 omega=pi/12.(ST-12);%太阳时角…
- User
D=0;ST=12;%日期、当地时间 omega=pi/12.(ST-12);%太阳时角 delta=asin(sin(2pi/365D).sin(2pi/36023.45));%太阳赤纬角 s=asin(cos(delta).*cos(0.688).*cos(omega)+sin(delta).*sin(0.688));%高度角 r=acos(sin(delta)-sin(s).*sin(0.688)/cos(s).*cos(0.688));%方位角 X=0;Y=0;Z=72;%塔相对位置和高度 x=A(:,1);y=A(:,2);%板位置 Rt=zeros(1745,1);
for i=1:1745 if x(i)<=X Rt(i)=pi./2-atan((Y-y(i))./(X-x(i)));%板出射光线方位 else Rt(i)=3*pi./2-atan((Y-y(i))./(X-x(i))); end end St=atan(Z./(((X-x).^2+(Y-y).^2).^0.5));
figure;
for j=1:1745 if Rt(j)>=r||Rt(j)>=pi+r Rv=(2*pi-Rt+r)/2; else Rv=(Rt+r)/2; %板法向方位 end end
Sv=(s+St)/2; plot3(x,y,Sv,'r'); hold off;
a1=sin(r).*cos(s); b1=sin(r).*sin(s); c1=cos(s); a2=sin(Rv).*cos(Sv); b2=sin(Rv).*sin(Sv); c2=cos(Sv); costhela=abs((a1.*a2+b1.*b2+c1.*c2)./(((a1.*a1+b1.*b1+c1.c1).^0.5).((a2.*a2+b2.*b2+c2.*c2).^0.5)));%余弦效率
at=0.99321-0.0001177.*(x.*x+y.y).^0.5+1.97e-8.(x.*x+y.*y);%透射率
ref=0.92;%反射率
niu=costhela.*at.*ref;
plot3(x,y,Rv) 这段代码中for j=1:1745 if Rt(j)>=r||Rt(j)>=pi+r Rv=(2*pi-Rt+r)/2; else Rv=(Rt+r)/2; %板法向方位 end end 这段代码有错误吗
- Assistant
Yes, there is an error in the code. The line
plot3(x,y,Rv) 这段代码中for j=1:1745is not closed properly with an end statement. It should be modified as follows:for j=1:1745 if Rt(j)>=r||Rt(j)>=pi+r Rv=(2*pi-Rt+r)/2; else Rv=(Rt+r)/2; %板法向方位 end plot3(x,y,Rv) endAdditionally, the line
plot3(x,y,Sv,'r');before the for loop should be inside the loop to plot the results for each iteration.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.