Skip to content
TheChatArchiveThe Chat Archive
gpt-3.5-turbo-0613· OpenAIAi2 WildChat-4.8M (AI2)

I need to know, is possible? using TL-WN722N not like WLAN, but as SDR in more wide…

  1. User

    I need to know, is possible? using TL-WN722N not like WLAN, but as SDR in more wide range than WiFi scanner?

  2. Assistant

    The TL-WN722N is a USB WiFi adapter manufactured by TP-Link. It is specifically designed for wireless networking and does not have the functionality or components to be used as a Software-Defined Radio (SDR) for a wider range than a WiFi scanner.

    SDRs are devices that can tune into a wide range of frequencies, including those used for WiFi, but they require specialized hardware and software to function. While the TL-WN722N can be used for WiFi scanning and monitoring, it is not intended for general-purpose SDR applications.

    If you are looking to perform SDR tasks in a broader frequency range than WiFi, you would need to purchase a dedicated SDR device that supports a wider frequency spectrum.

  3. User

    It is possible using TL-WN722N at low-level mode in ubuntu?

  4. Assistant

    Yes, it is possible to use the TL-WN722N in low-level mode (monitor mode) in Ubuntu. Monitor mode allows the adapter to capture and analyze raw packets on the wireless network.

    You can enable monitor mode on the TL-WN722N using tools like airmon-ng or iwconfig in Ubuntu. Here is a step-by-step guide to enable monitor mode on TL-WN722N in Ubuntu:

    1. First, ensure that you have the necessary drivers installed for the TL-WN722N on your Ubuntu system. In most cases, it should be automatically detected and supported by the kernel.

    2. Open a terminal and use the iwconfig command to check the wireless network interface name. It will be something like wlan0 or wlan1.

    3. Put the wireless interface into monitor mode by entering the following command in the terminal:

      sudo airmon-ng start [interface]
      

      Replace [interface] with the name of your wireless network interface.

    4. This will create a new interface in monitor mode, usually named mon0 or something similar. You can then use tools like Wireshark or Aircrack-ng to analyze the wireless traffic using the monitor mode interface.

    Note that while the TL-WN722N can be used in monitor mode to capture and analyze WiFi packets, it is not a full-fledged SDR device and may have limitations in terms of frequency range and advanced SDR functions.

  5. User

    Is possible engineering mode enable on TL WN722N ?

  6. Assistant

    No, the TL-WN722N does not have an "engineering mode" feature. It is a WiFi adapter designed for wireless networking and does not include any advanced or special engineering functionalities.

    The TL-WN722N is primarily used for connecting to WiFi networks and does not offer additional capabilities beyond that. If you are looking for an adapter with engineering mode or advanced features, you may need to consider other specialized hardware or SDR devices that are designed for those purposes.