Skip to content
TheChatArchiveThe Chat Archive
gpt-4-0314· OpenAIAi2 WildChat-4.8M (AI2)

Code arduino for 4 fan 12v 4 pin

  1. User

    Code arduino for 4 fan 12v 4 pin

  2. Assistant

    In order to control 4 12V 4-pin fans using an Arduino, you'll need a few more components to get started. Here's a list of recommended hardware:

    1. Arduino Uno or compatible board
    2. 4 x 12V 4-pin PWM fans
    3. 4 x N-channel MOSFETs (e.g. IRFZ44N) for switching the fans
    4. 4 x 10k ohm resistors to use as pull-down resistors
    5. External 12V power supply with enough current capability to power your fans
    6. Breadboard or PCB, jumper wires, and necessary connectors

    The circuit wiring would be as follows:

    1. Connect the ground of the 12V power supply to the ground of the Arduino.
    2. Connect the ground wire (black) of each fan to the drain pin of the corresponding MOSFET.
    3. Connect the source pin of each MOSFET to the ground of the 12V power supply (common ground).
    4. Connect a 10k ohm resistor from the gate pin of each MOSFET to the ground (acting as pull-down resistors).
    5. Connect the gate pin of each MOSFET to the corresponding PWM-capable Arduino pins.
    6. Connect the 12V power supply to the PWM fans' power wire (yellow or red, refer to the specific fan's datasheet).
    7. Connect the fan's PWM control wire (blue) to the corresponding Arduino pin.

    Here's an example Arduino code to control 4 fans using PWM:

    // Define PWM-capable Arduino pins for controlling each fan
    const int fan1Pin = 3;
    const int fan2Pin = 5;
    const int fan3Pin = 6;
    const int fan4Pin = 9;
    
    void setup() {
      // Set up the fan control pins as outputs
      pinMode(fan1Pin, OUTPUT);
      pinMode(fan2Pin, OUTPUT);
      pinMode(fan3Pin, OUTPUT);
      pinMode(fan4Pin, OUTPUT);
    }
    
    void loop() {
      // Set the PWM value for each fan (0-255)
      int fan1Speed = 255; // Full speed
      int fan2Speed = 170; // Medium speed
      int fan3Speed = 85; // Low speed
      int fan4Speed = 0; // Off
    
      // Apply the PWM values to the control pins
      analogWrite(fan1Pin, fan1Speed);
      analogWrite(fan2Pin, fan2Speed);
      analogWrite(fan3Pin, fan3Speed);
      analogWrite(fan4Pin, fan4Speed);
    
      delay(5000); // Wait for 5 seconds
    
      // Set new PWM values (Example: reversing the prior PWM settings)
      fan1Speed = 0;
      fan2Speed = 85;
      fan3Speed = 170;
      fan4Speed = 255;
    
      // Apply the new PWM values to the control pins
      analogWrite(fan1Pin, fan1Speed);
      analogWrite(fan2Pin, fan2Speed);
      analogWrite(fan3Pin, fan3Speed);
      analogWrite(fan4Pin, fan4Speed);
    
      delay(5000); // Wait for 5 seconds
    }
    

    This code will cycle all the fans through various speeds and will keep repeating the cycle. Adjust the fanXSpeed values in the loop to control how fast or slow fans should run. The delay() value is adjustable if you want the cycle to go faster or slower.