Skip to content
The Chat Archive
gpt-3.5-turbo-0301· OpenAI WildChat-4.8M (AI2)

翻译:FIG. 3. Basic qubit operations driven by SFQ pulses. (a) SFQ-based Rabi oscillations…

  1. User

    翻译:FIG. 3. Basic qubit operations driven by SFQ pulses. (a) SFQ-based Rabi oscillations as a function ofbias current i, to the SFQ driver circuit. Here, od = 010/3 ~ 1.65 GHz. (b) Rabi chevron experiment and (c) Ramsey fringe experiment where the SFQ pulse frequency Dd is varied slightly in the vicinity of oro/3. (d) Time trace of a SFQ-based Rabi flop obtained with a pulse rate 010/41 = 120.90 MHz. Inset: An enlargement of the discrete steps in Pr(D occurring every 8.3 ns, the SFQ pulse-to-pulse timing interval.

  2. Assistant

    图3. 通过SFQ脉冲驱动的基本量子比特操作。(a) 基于SFQ的拉比振荡波动,作为到达SFQ驱动电路的偏置电流i的函数。这里,od = 010/3 〜1.65GHz。(b) 拉比切尔文实验和(c) Ramsey相位实验,其中SFQ脉冲频率Dd在oro/3附近略微变化。(d) 使用脉冲速率010/41 = 120.90 MHz获得的基于SFQ的拉比翻转的时间追踪。插图:Pr(D每8.3纳秒发生的离散步骤,即SFQ脉冲与脉冲之间的定时间隔的放大。

  3. User

    vicinity of ω10/3\omega_{10} / 3 to produce the familiar "chevron" interference pattern. From the data we determine the length of SFQ-based π/2\pi / 2 and π\pi gates, which we denote as XSFQ/2X_{\mathrm{SFQ}} / 2 and XSFQX_{\mathrm{SFQ}}, respectively. For n=3n=3, the duration of the XSFQ/2(XSFQ)X_{\mathrm{SFQ}} / 2\left(X_{\mathrm{SFQ}}\right) gate is 14 (28) ns, corresponding to 23 (46) discrete SFQ pulses. From the measured Rabi frequency and Eq. (1) we determine the coupling capacitance Cc=400aFC_c=400 \mathrm{aF} between the driver and qubit circuits. Once the XSFQ/2X_{\mathrm{SFQ}} / 2 gate is defined, we perform a Ramsey interferometry experiment [Fig. 3(c)]; we obtain familiar interference fringes oscillating with a frequency corresponding to three times the detuning of the SFQ pulse train from ω10/3\omega_{10} / 3.

  4. Assistant

    为了产生熟悉的“V形”干涉图案,我们将SFQ脉冲的频率Dd在ω10/3\omega_{10} / 3附近略微变化。从数据中,我们确定基于SFQ的π/2\pi / 2和π\pi门的持续时间,分别表示为XSFQ/2X_{\mathrm{SFQ}} / 2和XSFQX_{\mathrm{SFQ}}。对于n=3n=3,XSFQ/2(XSFQ)X_{\mathrm{SFQ}} / 2\left(X_{\mathrm{SFQ}}\right)门的持续时间为14(28) ns,对应于23(46)个离散的SFQ脉冲。通过测量拉比频率和公式(1),我们确定了驱动电路和量子比特电路之间的耦合电容为Cc=400aFC_c=400 \mathrm{aF}。一旦定义了XSFQ/2X_{\mathrm{SFQ}} / 2门,我们执行了一个Ramsey干涉实验[图3(c)];我们得到了熟悉的干涉条纹,其振荡频率对应于SFQ脉冲列与ω10/3\omega_{10} / 3的失谐三倍。

  5. User

    翻译:For SFQ drive at a subharmonic of the qubit frequency, timing shifts between sequences induce a faster rotation of the angle of the control vector by ¢n= M010T, where n is the subharmonic drive factor. Figures 4(b) and 4(c) display generalized 2D Rabi data for qubits driven with SFQ pulse trains at 010/3 and D1o/41, respectively. A Rabi pulse with varying duration and phase is inserted between two SFQ-based T /2 gates whose timing defines the X direction. In these plots, the duration t of the control sequence is encoded in the radial direction, the polar coordinate is given by the phase of the SFQ trigger tone at frequency od 一 D10 / n, and the measured qubit population is plotted in false color. We see clear 2n-fold symmetry in the scans: pulse trains shifted by 2T /n@1o are equivalent,

  6. Assistant

    对于以量子比特频率的子谐波为驱动的SFQ,序列之间的时间偏移会使得控制矢量的角度以更快的速度旋转,旋转角度为¢n=M010T,其中n是子谐波驱动因子。图4(b)和4(c)分别显示了以010/3和D1o/41驱动的量子比特的广义二维拉比数据。在两个SFQ基于T /2门之间插入了一个持续时间和相位变化的拉比脉冲,其时序定义了X方向。在这些图中,控制序列的持续时间t编码在径向方向上,极坐标是由频率为od – D10 / n的SFQ触发音的相位给出的,测量得到的量子比特群体在假色中绘制。我们可以看到扫描中明显的2n阶对称性:每隔2T/n@1o的脉冲列是等效的,

  7. User

    翻译By triggering the SFQ driver at a much lower frequency and delivering a dilute SFQ pulse train to the qubit, we can map out the terraced trajectory of the qubit state vector on the Bloch sphere evoked by the name of the DANTE pulse sequence. In Fig. 3(d) we show data from a qubit Rabi flop obtained with an SFQ pulse train triggered at a deep subharmonic ωd=ω10/41\omega_d=\omega_{10} / 41. The discrete steps induced by the individual SFQ pulses are evident and emphasized in the figure inset.

    Any complete qubit control scheme requires rotations about orthogonal axes. In the case of conventional microwave-based qubit control, the direction of the rotation is set by the phase of the pulse. For SFQ-based control, the relative timing of two resonant SFQS F Q pulse trains determines the directions of the corresponding control vectors in the equatorial plane of the Bloch sphere. We first consider the case of resonant drive at the qubit fundamental frequency. We arbitrarily choose the relative timing of one sequence to correspond to the XSFQX_{\mathrm{SFQ}} rotation. For a second resonant pulse sequence that is shifted in time by τ\tau with respect to the first, the qubit sees a control vector that is rotated by an angle ϕ=ω10τ\phi=\omega_{10} \tau in the equatorial plane. For example, the pulse train for the YSFQY_{\mathrm{SFQ}} gate is shifted by an amount τ=π/2ω10\tau=\pi / 2 \omega_{10} (one quarter of an oscillation period) with respect to that of the XSFQX_{\mathrm{SFQ}} gate; see Fig. 4(a). In prac-

  8. Assistant

    通过以较低的频率触发SFQ驱动器并向量子比特传递稀疏的SFQ脉冲序列,我们可以绘制出由DANTE脉冲序列所唤起的量子比特状态矢量在布洛赫球上的梯形轨迹。在图3(d)中,我们展示了在一个深度子谐波ωd=ω10/41\omega_d=\omega_{10} / 41频率下触发的SFQ脉冲序列产生的量子比特拉比翻转数据。在该图的插图中,个体SFQ脉冲引起的离散步骤是明显的,并受到强调。

    任何完整的量子比特控制方案都需要绕正交轴进行旋转。在传统基于微波的量子比特控制中,旋转的方向由脉冲的相位确定。对于基于SFQ的控制,两个共振的SFQSFQ脉冲序列的相对时序决定了布洛赫球赤道平面对应控制向量的方向。我们首先考虑共振驱动量子比特基频率的情况。我们任意选择一个序列的相对时序对应于XSFQX_{\mathrm{SFQ}}旋转。对于第二个与第一个序列相对时间偏移τ\tau的共振脉冲序列,量子比特会看到在布洛赫球赤道平面上被旋转了ϕ=ω10τ\phi=\omega_{10} \tau的控制向量。例如,YSFQY_{\mathrm{SFQ}}门的脉冲序列相对于XSFQX_{\mathrm{SFQ}}门的脉冲序列偏移了τ=π/2ω10\tau=\pi / 2 \omega_{10}(一个振荡周期的四分之一);见图4(a)。在实际中,