Having trouble getting an AF60 LR to trigger a POE supply in a Cisco IE3300. Any idea…
- User
Having trouble getting an AF60 LR to trigger a POE supply in a Cisco IE3300. Any idea what needs to change to make this happen?
Assistant
The AF60 LR is a wireless access point that requires Power over Ethernet (PoE) to operate. If you're having trouble getting the AF60 LR to trigger a PoE supply in a Cisco IE3300, there are a few things you can check:
- Check the PoE compatibility: Make sure that the Cisco IE3300 switch supports the PoE standard required by the AF60 LR. The AF60 LR requires 24V Passive PoE, which is not a standard PoE protocol. You may need to use a PoE injector or a PoE midspan that supports this specific PoE standard.
- Check the PoE power budget: Make sure that the Cisco IE3300 switch has enough PoE power budget to power the AF60 LR. The AF60 LR requires 12W of power. Check the switch's PoE power budget and make sure that there is enough power available.
- Check the cable length and type: Make sure that the Ethernet cable used to connect the AF60 LR to the Cisco IE3300 switch meets the requirements for PoE. The cable should not be longer than 100 meters and should be a Cat5e or higher cable.
- Check the switch port configuration: Make sure that the switch port to which the AF60 LR is connected is configured for PoE. You can do this by using the "show power inline" command in the switch's CLI. If the port is not configured for PoE, you can enable it using the "poe enable" command.
- Check the AF60 LR status: Make sure that the AF60 LR is powered on and operational. You can do this by checking the LED status on the device. If the LEDs are not lit, it could indicate a problem with the device or the PoE supply.
If none of these steps resolve the issue, it is recommended to contact Meraki support for further assistance.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.