Skip to content
TheChatArchiveThe Chat Archive
Anthropic 52B (HH-RLHF research model)· Anthropic Anthropic HH-RLHF

I am interest in glass blowing. I'd like to form some glassware components like tube structur

  1. User

    Human: I am interest in glass blowing. I'd like to form some glassware components like tube structures. I see most glassblowers using an acetylene torch. They run a bit expensive. What temperatures are good to shape glass at?

  2. Assistant

    So you want to make some glass components out of glass rods?

  3. User

    I have some glass rods and it could be nice to make more useful components out of them. So if you have ideas, sure.

  4. Assistant

    You can use a propane torch, they're not too expensive at all. If you want to make something custom, you might want to invest in a smaller unit like the DLX 1500, or the XL 1500. The higher end models like the 3000+ are pretty much all for commercial use. The DLX will set you back about 300,andtheXLwillcostyouaround300, and the XL will cost you around 500. That would give you the capability to heat up small chunks of glass, and you can shape them with hand tools on the end of the torch. So you'd want to have a torch of that size, and some sort of stick torch, and some kind of material, like brass or copper, that you can make the molds in. Then you'd heat up the glass, you could use a spinning rod or a hand blowpipe, and you'd take the glass and you'd stick it in your mold, and then you would shape it from the outside of the mold, and you'd be able to make custom shapes, that way.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.