Skip to content
TheChatArchiveThe Chat Archive
Mistralmistral-7b-instruct· Mistral AIHugging Face Arena Human Preference 55K

Learning code on the most commom RC transmitter with 3 buttons use one width of pulse to…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with gpt-4-0314’s answer.
  1. User

    Learning code on the most commom RC transmitter with 3 buttons use one width of pulse to represent 1 and other width to represent 0, tell all about these widths.

  2. Mistral Assistant

    The width of the pulse refers to the amount of time the signal is "on" or "high" in an RC transmitter. The pulse width modulation (PWM) used in RC transmitters allows for the transmission of digital data using a continuous analog signal.

    In a typical RC transmitter, the pulse width is determined by the duration of the pulse between two consecutive "0" states or between two consecutive "1" states. For example, if the pulse width is 500 microseconds (us), then each "1" state in the digital signal would have a pulse width of 500us, while each "0" state would have a pulse width of 0us.

    The pulse width can be adjusted to represent different values in the digital signal. For example, a pulse width of 1000us would represent a "0" state, while a pulse width of 2000us would represent a "1" state.

    It's important to note that the pulse width used in an RC transmitter may vary depending on the specific device and manufacturer. It's also important to ensure that the pulse width is consistent and accurate in order to properly interpret the digital signal received by the receiver.

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.