A disk of rotating circumstellar material (gas and dust) usually forms around a growing…
- User
A disk of rotating circumstellar material (gas and dust) usually forms around a growing protostar as a consequence of angular momentum conservation during cloud collapse. The initial stages of the disk are quite turbulent due to infall of material on the disk. This period is followed by a quieter state, during which the dust settles towards the middle plane of the disk (see Chapter 5.10). A radial temperature gradient is present in the disk due to viscous heating, which causes higher temperatures in the inner regions because of a stronger Keplerian shear (see Chapter 11.5). The so- called “snow line” or “frost line” marks the radial distance at which the disk temperature drops below the condensation temperature of a particular ice (H2O, CO2, CO, CH4, NH3). For example, the “frost line” of water ice is located around 3–5 au for circumstellar disks around solar type stars, while the carbon dioxide, methane and carbon monoxide lines are located outwards at lower temperatures. Circumstellar disks around stars have been detected with different methods, either with the infrared excess in the power spectrum of a star or via direct imaging with high-resolution instruments (HST, ALMA, SPHERE …). If a circumstellar disk is present around a star, its dust emits at a lower temperature with respect to the star and its blackbody radiation falls within the infrared spectral range (see Appendix C). As a consequence, the observed spectrum of the star is given by the combination of that of a blackbody with a superficial temperature of about 6,000 K (for solar-like stars) and that of a colder source (the disk) with a temperature below 1,000 K, the infrared excess. In Fig. 1 an example of infrared excess in the spectrum of a star is shown. If we imagine to divide the disk in rings with different temperatures, it is possible from the morphology of the infrared excess to deduce if the disk has gaps or an inner hole like in transition disks.
Please explain to me, step by step, the above excerpt from a book on Astrophysics.
Assistant
Of course! Let's break down the information step by step to make it easier to understand:
-
Disk Formation: A disk of rotating circumstellar material forms around a growing protostar due to the conservation of angular momentum during the collapse of a cloud. This conserves the rotational energy while the star is still in its forming process.
-
Turbulence in the Disk: Initially, the disk goes through a turbulent phase as material from the cloud continues to fall towards the central protostar, creating infall.
-
** Dust settling**: After the turbulent phase, dust particles settle towards the disk's mid-plane, as the infall slows down, giving the disk a more ordered appearance.
-
Temperature Gradient: The disk has a radial temperature gradient, which is caused by viscous heating. The inner regions experience a stronger shear due to Keplerian rotation (moving at a nearly constant speed), resulting in higher temperatures.
-
Temperature lines:特定冰雪的"雪线"或"冻结线"标识出温度下降的点,低于这些化合物的凝固温度,如水冰(3-5天文单位,AU)对于类太阳恒星,而二氧化碳、甲烷和一氧化碳的"冻结线"位于更外侧且更低的温度区域。
-
Detection Methods: 环绕恒星的这些disk可以通过两种方式检测:一是观测恒星的红外(热)光谱特点,表现为比恒星本身温度低的额外辐射;二是利用高分辨率仪器(如HST, ALMA, SPHERE等)直接进行成像。
-
Infrared Excess: 恒星的红外增宽部分是由于它发出的恒星黑体辐射(约6,000 K,类似于太阳)与散发较低温度的冷源——星际盘的组合。因此,观测到的星体光谱是这两个辐射的组合。
-
Disk Morphology: 将星际盘划分为不同温度的环,通过观测红外增宽的形状可以推断盘是否存在孔洞或过渡盘(如双环系统)的特征。
简而言之,星际盘是恒星形成过程中的重要组成部分,它从形成时的混乱逐渐稳定并产生温度分层,通过观测可以揭示其结构信息。
-
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.