Skip to content
TheChatArchiveThe Chat Archive
gpt-4-1106-preview· OpenAIHugging Face Arena Human Preference 55K

Write a PPC64 assembly function to load a function from the GOT and branch directly to it

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with gpt-4-0314’s answer.
  1. User

    Write a PPC64 assembly function to load a function from the GOT and branch directly to it

  2. Assistant

    The Global Offset Table (GOT) is used in the PowerPC 64-bit (PPC64) architecture to support position-independent code by holding the addresses of global variables and functions that are accessed by a program. When writing assembly to load a function from the GOT and branch to it, we need to perform an indirect function call through the GOT.

    Here's an example of a PPC64 assembly function that does this, using the ld instruction to load a 64-bit value from a memory address and mtctr/bctr to branch to the address loaded into the Count Register (CTR):

    .section .text
    .globl call_function_from_GOT
    .type call_function_from_GOT, @function
    
    # void call_function_from_GOT(uint64_t got_entry_offset)
    # r3: contains the offset of the function in the GOT
    call_function_from_GOT:
        # Load the address of the GOT into r11
        # Assuming r2 holds the address of the TOC base (TOC pointer)
        ld      r11, 0(r2)
    
        # Load the function address from the GOT using the offset in r3
        # r11 = address of GOT
        # r3 = offset of the desired function in the GOT
        ld      r12, 0(r11, r3)
    
        # Move the function address to the Count Register (CTR)
        mtctr   r12
    
        # Branch to the function address in the CTR
        # and link (save the return address in the Link Register)
        bctrl
    
        # Function end
        .size call_function_from_GOT, .-call_function_from_GOT
    

    This function expects the offset of the desired function within the GOT to be passed in the r3 register. It loads the address of the GOT into r11 and then uses the offset in r3 to load the function's address from the GOT into r12. Finally, it moves the function address to the CTR and performs an indirect branch to the function, saving the return address in the Link Register (LR) so that the function can return to the caller.

    Please note that the exact implementation may vary depending on the calling convention, the ABI, and the specific details of how the GOT and the TOC (Table of Contents) base are set up in your environment. The above code assumes that r2 holds the address of the TOC base,

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.