My Bluetooth headphones have no audio. I can connect them on Linux using Blueman, but…
- User
My Bluetooth headphones have no audio. I can connect them on Linux using Blueman, but the sink is not listed in pavucontrol. I'm using Pipewire.
Assistant
It sounds like your Bluetooth headphones are successfully connecting to your Linux system, but are not being used as the audio output device. This can happen if the Pipewire service does not recognize the headphones as an audio sink.
Here are a few steps you can try to troubleshoot the issue:
- Make sure that your Bluetooth headphones are in pairing mode and discoverable.
- Use the Blueman applet to connect to your headphones. Once connected, try playing some audio to see if it comes through the headphones.
- Open a terminal and run the following command to check if Pipewire recognizes your headphones as an audio sink:
pactl list sinksYour headphones should be listed as one of the sinks. If it's not listed, it's possible that Pipewire is not recognizing your headphones as an audio device.
- Try restarting the Pipewire service. You can do this by running the following command in a terminal:
systemctl --user restart pipewire- After restarting Pipewire, try connecting to your headphones again and check if they are listed as an audio sink using the
pactl list sinkscommand. - If your headphones are still not being recognized as an audio sink, try uninstalling and reinstalling Pipewire.
- If none of the above steps work, it's possible that there is an issue with your Bluetooth headphones or your Linux system's Bluetooth driver. In this case, you may need to consult the manufacturer's documentation or seek further assistance from the Linux community.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.