Skip to content
TheChatArchiveThe Chat Archive
Mistralmixtral-8x7b-instruct-v0.1· Mistral AIHugging Face Arena Human Preference 55K

When I reset a Osram smart bulb doing the on-5-sec/off-5-sec sequence four or five…

From a Chatbot Arena battleThe same person sent this prompt to two anonymous models at once. Compare it with Claudeclaude-2.1’s answer.
  1. User

    When I reset a Osram smart bulb doing the on-5-sec/off-5-sec sequence four or five times, I see it pairing with zigbee2mqtt and I can see its binary friendly name (0x7cb03eaa0a043be1) equal to its ieee_address. Using mosquitto, how do I write a command to toggle the light on and off?

  2. Mistral Assistant

    To toggle an Osram smart bulb on and off using zigbee2mqtt and mosquitto, you can publish a message to the MQTT topic associated with the bulb's Zigbee endpoint.

    First, you need to determine the endpoint number for the bulb's main functionality. You can find this by looking at the endpoints field in the device's information in the zigbee2mqtt web interface. The main endpoint for a smart bulb is often 1.

    Once you have the endpoint number, you can toggle the light on and off by publishing a message to the MQTT topic for the bulb's state attribute on that endpoint. The topic will be in the format:

    zigbee2mqtt/<ieee_address>/<endpoint_number>/state
    

    So for your bulb with the IEEE address 0x7cb03eaa0a043be1 and endpoint number 1, the topic would be:

    zigbee2mqtt/0x7cb03eaa0a043be1/1/state
    

    To toggle the light on and off, you can publish a message with the payload {"state": "TOGGLE"}. You can do this using the mosquitto_pub command-line tool like this:

    mosquitto_pub -h localhost -t zigbee2mqtt/0x7cb03eaa0a
    

Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.