claude-2.0· Anthropic Arena Human Preference 55K
write VHDL UART transmitter. It should take 8-bit word as input, output clock is divided…
- User
write VHDL UART transmitter. It should take 8-bit word as input, output clock is divided by configurable amount from the input clock. Transmit is started by writing one cycle high pulse to W std_logic input.
- Assistant
Here is an example VHDL code for a simple UART transmitter:
library ieee; use ieee.std_logic_1164.all; entity uart_tx is generic ( CLK_FREQ : integer := 50_000_000; -- System clock frequency in Hz BAUD_RATE : integer := 115200); -- Baud rate port ( clk : in std_logic; tx_en : in std_logic; -- Transmit enable (one clock pulse) din : in std_logic_vector(7 downto 0); -- Input data tx : out std_logic); -- UART output end uart_tx; architecture behavior of uart_tx is constant CLK_DIV : integer := CLK_FREQ / BAUD_RATE; signal tx_reg : std_logic; signal tx_cnt : integer range 0 to CLK_DIV-1 := 0; signal tx_bit : integer range 0 to 7 := 0; begin tx_proc: process(clk) begin if rising_edge(clk) then if tx_en = '1' then tx_cnt <= 0; tx_bit <= 0; elsif tx_cnt = CLK_DIV-1 then tx_cnt <= 0; if tx_bit = 0 then tx_reg <= '0'; elsif tx_bit < 8 then tx_reg <= din(tx_bit); tx_bit <= tx_bit + 1; else tx_reg <= '1'; -- Stop bit end if; else tx_cnt <= tx_cnt + 1; end if; end if; end process; tx <= tx_reg; end behavior;This transmits each input 8-bit word along with a start bit (logic 0) and stop bit (logic 1). The baud rate is configurable by changing the CLK_DIV constant. The transmit enable signal tx_en pulses for one clock cycle to begin transmission. A counter tx_cnt implements the clock divider, while tx_bit keeps track of the bit position during transmission.
Other models, same or similar prompt
Responses were produced in different, uncontrolled contexts (system prompts, settings, prior turns). This is not a benchmark.